Jet Soft Stands- For Building, Transport and Assembly

Pacific RC Jets

$99.00 
← Previous Product
Share:

Soft Stand- For Building, Transport and Assembly

PLEASE NOTE: These soft stands ship in two different boxes, you may receive one box before the other.

 Benefits:

  • Provides stable support for jets on bench, worktable or transport
  • Non-slip surface- holds jets from sliding while building or transporting
  • Soft enough to not scratch fine finishes
  • Standard soft foam contour pads fit most jet profiles (supplied U shape)
  • Customizable- trim the foam for a more exact profile (using a serrated kitchen or electric knife)
  • Adjustable footprint- extend the foam pads along the rails to fit almost any size build, transport or assembly need
  • Light weight and easy to handle- less than 3 lbs.
  • Grips well- reposition your build so the top of the fuse is angled towards you for easy access
  • Aligning the rear pad under the wing will stabilize the plane when only one wing panel has been installed
  • Flip the stand over to provide additional height. On many models this will allow an inverted jet to clear the turtle deck
  • Smaller models will have enough clearance for full gear swing.
  • Optional “6” risers” fit underneath stand allowing gear swing on larger jets
  • Easy disassembly for storage or transport
  • Fuel, alcohol and glue resistant
  • Optional “blank” foam blocks allow the builder to customize each pad for an exact fit (with electric knife or serrated kitchen knife).

 

Sizes:

  • T3- (2) 6” x 8” x 18” foam pads, 2 poles are 48” long. Front and back pads have gentle “U” curve
  • T1- (2) 4” x 8” x 18” foam pads, 2 poles are 36” long. Front and back pads have gentle “U” curve

 

Options:

  • 6” x 6” riser blocks (pr) to fit under the stand and provide additional clearance for larger jet gear swing
  • 4” x 8” x 18” Blank Pads (pr) if you want to cut your own
  • 6” x 8” x 18” Blank Pads (pr) if you want to cut your own

 

Configurations:

  • Set jet right side up for building, storing or transporting
  • Roll jet 45 degrees towards you for easy access into fuse for building
  • Flip jet upside down for easy access to bottom
  • Flip stand over to gain additional height
  • Add option riser blocks to clear gear swing or turtle deck (if inverted)

 

Assembly:

  • Push 2 poles through 1” holes in each of the foam pads
  • Adjust length so the front pad is directly under a former and rear pad is either under a former or under the wing

 

 

You may also like...